Hello
Nx Version : 11 TcE Integerated
For i have received some guidelines for assembly modelling.
- To align the Shaft to Hole (Center to center constrain) we should always use the Align and we should not use the Touch constraint.
- While constraining we should select the second component first and then we should select the first component. Example : If a bolt is assembled in the fully constrained flange then bolt will be second component and we need to select the center of bolt for align constraining.
Now the issue is while try to `Align’ command in `Touch Align’ most of the times it change the bolt direction (i.e., changing the bolt entry to flange – left to right or right to left like that, if a bolt is being assembled in engine front flange then bolt entry will be front radiator side or back reverse clutch side). We are try to use the `Reverse Last Constraint’ option and now the bolt entry is corrected per assembly, but the issue is `Align’ is changed to `Touch’.
Is there any solution to resolve or fix this issue.
Thanks in advance
Thilagaraj