Hello, While in an assembly, I made a sheet metal part the working part and then made a Normal Cutout - and referenced some holes that were in the assembly. After finishing the cutout, I got a warninng that said the internal sketch could not be resolved. "Update Warning and Failure Report"
I then went into the part and worked on the cutout and even removed all constraints and then re-dimensioned everything and added new constraints. I even re-attached the sketch, but I'm still getting the same original warning:
SB Normal Cutout(11) Warning: Placement of the internal sketch cannot be resolved due to parent conflicts. Reattach the s
ketch.
Warning: Unable to reference parent objects that are either suppressed or modeled away.
The final cut looks OK, but still has that warning. Should I just assume it's OK and leave it alone or is there something I can do to fix it. I don't like leaving features with warnings, but I'm not sure what else to do. Thanks