Hello everyone!
At that moment when I want to created a view normal to a specific plane or face, I choose it and press F8. Then I save orientation as a new Model View. That kind of defenition is not associative.
Is it possible to make a Model View associative to geometry it has been defined by? That when an angle of the plane changes, view is also reoriented.
The intent is to use that view and PMIs in a drawing later. But when geometry changes you have to manually redefine a Model View, then an orientation plane for some PMI (cause they are oriented in obsolete plane position), and at last to redefine a view in the drawing, because it is also not associative to a Model View it was taken from.
Thank you in advance