Custom symbols error

Hi,

I've almost completely setup NX as how I require and I've run into quite some problems setting it up. Now I'm trying to setup custom symbols. 

I go into customer defaults -> gateway -> (...) -> Symbols library and add a folder location there, with the folder name in front of the | line. I close down NX and restart it. Create a new model -> drafting and try to create custom symbols. The folder that I created shows up.

I'll draw the symbol that I need, define the symbol and when I save it I get an "internal error: memory access violation". 

>>>> O/S ERROR: signal 11 caught in file "o:\ugnx110\ip33\src\dman\no\ind\undo_ug.c" at line number 1665
>>>> O/S ERROR: signal 11 caught in file "o:\ugnx110\ip33\src\dman\no\ind\undo_ug.c" at line number 1672
&MACRO FOCUS CHANGE IN 1
&MACRO MESSAGE_BOX -2, Error recovery failed because:
&MACRO MESSAGE_TEXT Internal error: memory access violation
&MACRO MESSAGE_TEXT 
&MACRO MESSAGE_TEXT Parts in this session may be corrupt. Do not save your parts.
&MACRO MESSAGE_TEXT Restarting NX is recommended.
*** EXCEPTION: Error code 11 in line 2371 of o:\ugnx110\ip33\src\part\no\ind\Part_BasicSaveManager.cxx at Tue May 02 09:35:29 2017 W. Europe Daylight Time
+++ Failed to undo after start save failure

I've added the part of the syslog that shows what went wrong.

I was hoping someone else experienced the same thing and it was an easy overlooked fix.

It'll only save a .bmp file.