I have noticed that when I include a view of an assembly component into a drawing for the top level assembly, NX is adding another component to my assembly. So basically, if I have an assembly -010 and there are two -010-001 components that are part of that assembly, if I add a view of the sub component -010-001 in my drawing for the -010 top level assembly, NX adds an additional -010-001 to my -010 assembly, so no my tree says that I am using three -010-001 components instead of the two that are actually part of the assembly.
Additionally, if I export the -010 top level assembly, I end up with an extra -010-001 in a completely different coordinate system. We've worked around the problem in the past, but I'm sure there is something that I must be doing incorrectly or a box I'm forgetting to check that is causing this issue.
Any assistance would be greatly appreciated.
Thanks