Hello Community,
I just do not understand the Layer behavior in assemblies.
I have an assembly with a few components A, B, C. In the components A and B I have Bodies on Layer 1.
In component C I have linked bodies from A and B. These linked bodies in Component C I put on on layer 93.
In the assembly I switched off layer 93 so the only layer that's on is layer 1. That means I see all bodies that are on layer 1 of any component.
Problem: I also see the linked bodies from component C that are on layer 93 only.
I have tried a lot but I still see collisions because the bodies are the same and at the same place of course.
Please help me!
Many thanks for suggestions
I cannot get them
