Pin Listing

Hi, 

I use NX 12.0 for Electronical Routing. 

I would like to use Pin Listing Command on Drafting application of Electrical module. 

In this Pin Listing table, I want to show Unique ID which gives signal name pass through on each cable, pin number that reject from each pin terminal, and on the top of the table(header) I want to show connector ID. 

I tried this issue by using Cut Sheet Annotation, but it gives me wrong results. For example, I used from_conn command to see connector ID but it gives me connector id that other connector cables come from. I just want to see Connector ID that I selected for pin listing command. 

Thanks for advance.