Hello, While dealing with the other stuff that I listed in the previous post, I just now noticed some strange behavior with the "Center" constraint. I had constrained a part using three constraints and one of them was the Center constraint. It failed, which wasn't surprising, but what was surprising was that it was the Center constraint. All I had to do was do a "reverse" for the Center constaint and the failure was resolved.
When setting the Center constraint, I was using the "1 to 2" subtype. For selecting the "2 features", does it matter what order I select the 2 features? I don't recall this being a problem or factor in NX 10, but it appears that the order that I pick the 2 features determines how the part is oriented. Is it supposed to be that way? Again, I didn't notice this in NX 10. Thanks