Drawing Standards / thread callouts / surface finish symbol production

Hey guys

I have to two questions about the drawing standard.

NX 10 to NX 12

Thread callouts

1. When I create a UNC thread in the model. In the drawing just the inch dimensions are shown but not written which thread like UNC etc. With some threads it works on what does this depend?

I tried to add entries in the nx502_Threaded_Hole_Standard.xml file. But did not help. Where is this attribute controlled?

Surface finish symbol production

2. Where are the lagnauge files for following entry in the drawing standards.dpv for

Drafting_SFproductionList. The entries are just in english but where do I change the german ones etc.?

Because the standard in German is that the words have to be in past.

Best Regards

Winn Chelini