Hello I have a problem with a current drafting I am working on. The part I am drawing is a square mount with some holes in it ( you can look at the professionally made drawing that is maid in paint that I attached because I am currently not at my work and therefore I don't have access to nx right now). The problem I have is that when I create a section view of the 2 holes to make them visible. But since the holes are on an angle on the workpiece I can't get the view to line up or fit in the current draft. Is there anyway to get the same sectionview and rotate it 30 degrees so it will be parallel and I then can place it where I would want it to be ?
(The sectionview is needed because the holes are complicated)