Editing line geometry in NX 10

Good morning,

  Just switched over to NX10 from 8.5 and am having some issues in editing basic curve geometry. Previously, we were able to double-click a curve and along with a Edit Curve pop up there would be a pop up with XYZ coordinates, arc and arc length. AND the ability to change line length direction whether it was a straight line or arc.

THe question, is this option now gone or is it an option that needs turned on ? Trying to figure out the new system, a new workstation, a hot project and Catia training all at once so some help would be appreciated.

Thanks,

Kirk