Hello,
NX is currently acting more sluggish, so I'm wanting to see if anything can be done to speed it up. I'm supposed to be getting a new computer, so I don't want to consider hardware changes or anything like that. Would it be helpful for me to uninstall NX and re-install it or is there something less drastic that can be done?
I notice it especially being slow when I have coordinate systems and other datums displayed in an assembly. I wasn't sure if this was just typical for NX or if there is a problem.
I try to run "ccleaner" when my computer is acting slow. I had also seen from this site, or another, that NX doesn't do well with RAM, so it was recommended to close NX and restart the computer daily; so I have been doing that as well. Thanks