Hello everyone!
I am working with a part geometrically similar to the one attached below.
The problem here is I have two options to get the required surface (there are many others as well, but these match very closely with what I require).
So, essentially, I am trying to get a surface created from a set of curves. Now fill surface in this case seems to be a faster way to achieve the result compared with through curve mesh. On the other hand though, through curves mesh takes time (just a little bit more) but the end result is very different.
Why are the results different? That's my question.
I have kept all the parameters almost identical.
Check the part files attached & these pictures for reference.
Fill Surface
Through Curve MeshThanks in advance.