- "myLine": vertically above X axis, center point on Z axis
- "SKETCH_000": two points on Y axis
- "myConic": constrained on XY plane, start/end points = ends of "myLine", interior/anchor points = "SKETCH_000" points
I'm surprised to find "myConic" has no dependency on "myLine"! Do I miss something? Or this is the nature of General Conic? Thanks!
![ScreenClip [2].png](http://siemensplm.i.lithium.com/t5/image/serverpage/image-id/49196i78F5792834557F1B/image-size/large?v=1.0&px=999 "ScreenClip [2].png")
![ScreenClip [3].png](http://siemensplm.i.lithium.com/t5/image/serverpage/image-id/49197i3AACAAEC8ABCA17A/image-size/large?v=1.0&px=999 "ScreenClip [3].png")