I downloaded the updated Topology Optimization add-on "NX 12.0.0 Update 01 - NX30556 Topo Opt..." released Nov 14 and set it up to run in NX11 and NX12 (the downloaded zip file contains software for both NX11 & NX12). The problem is that I can't make it work properly on either.
For new models I can go on setting up the optimization until clicking "Estimate Optimization Parameters" in "Setup Optimization" where it crashes with a Block Styler error on both NX11 and NX12. So I can't even start the optimization.
For models previously created with older versions of Topo Opt I can run the optimization since I don't have to click "Estimate Optimization Parameters" to have "Run Optimization" available. If I click "Estimate Optimization Parameters" on these models the same Block Styler error occurs.
I've tried to download and set up the files again, but with the same results.
Anyone else with this problem? Any suggestions on how to solve this?
