Quantcast
Channel: NX Design Forum topics
Viewing all articles
Browse latest Browse all 5175

NX 11 Large sketch settings

$
0
0

Hi,

 

I am running into a problem where sketchs become large enough to where the large sketch settings apply.  At that point the "create inferred constraints" setting is turned off.  Problem is that you have to continouly turn it back on.  IE, i want to add a profile, open sketch (in task enviroment), click CIC (create inferred contraints button) or click checkbox in sketch settings tab, then click profile button and it is disabled there also, so click CIC button again, then draw geometry.  But now after drawing said geometry, the CIC option has been disabled once again.   Every time i want to create a new curve while still in the sketch editor task enviroment, i i have re-click the CIC after pressing the desired curve button (ie profile, rect., circle, trim mirror ect...)

 

This is extremely annoying and makes editing these sketch very tedious.  Is there anyway to turn off the large sketch optimization settings in the customer defaults?


Viewing all articles
Browse latest Browse all 5175

Trending Articles