Hello, I have a large/multi-page drawing that I'm working on and I want to see if there's a simpler way to change attributes. For this drawing, I'm need to change several attributes, so I find the drawing in the Assembly Navigator, RMB, Properties. At this point, the Displayed Part Properties window opens and I scroll down to the particular Part Attributes that I'm wanting to change. I then select the attribute and change the window in the field on the RH side. Once the value is entered, I either select Enter to accect the edit or hit tab and then hit the green check mark for Accepting Edit.
Once I hit Enter or Accept Edit, the list of Part Attributes automatically goes all the way back up to the top of the list and I have to scroll back down to make the next change. Am I doing this wrong because it's very cumbersome? It would be nice if I could accept the edit and then the list would stay where it was instead of jumping back up to the top of the list. Is it possible to be able to export the list into Excel, make the changes and then save the changes back to NX? Thanks