I am looking for a way using expression logic to limit a number of wedges assembled together based on the angle of each wedge and the total angle of the assembly of wedges.
In the attached file, I have an assembly of 8 wedges each with angle B. The total angle of all the wedges in the assembly is angle A. The limit of angle A is less than or equal to 120 degrees. Angle B could be 3 different angles. Wedges 3-8 are inserted based on a desired total of angle A, but cannot exceed 120 degrees. I would like to come up with a way based on this that as I am inserting wedges 3-8 either the expressions force another angle on a particular wedge so Angle A does not go over 120 degrees or if that is not possible, just forces the input to 0 so the wedge and subsequent wedges are forced off.
I know conditions can be set up to flag an expression that does not fit into the applied condtion as its defined, but this is not very obvious to the user changing the various wedges out in the assembly.
Hopefully this makes sense.
Thank you for any help anyone can provide.