NX 7.5 - Replace Component in Drawing

Its been 13 years since using NX.

Been using SolidWorks.

I was sent a model and a drawing that were emailed out of TeamCenter.

Both files are now saved to a local folder.

When I open the drawing, it errors that it cannot locate the model that is now listed as a long, wierd file name.

Right clicking on the missing model only shows these options.

There isn't a Replace Component

.

I have also tried renaming the model to the wierd file name, but still get same error when opening drawing.

Thank you,

TEngle

NX 7.5