Hi all,
running NX 8.5.1.3 on Win7SP1x64 / Xeon@2.53GHz / 12GB RAM / Quadro FX1800.
I have a small assembly with 33 individual components (220 total), simple mechanical parts of a conveyor. Whenever I change (or create new) an attribute of a component and hit OK to apply changes NX freezes for a minute or two with "Updating objects..." message. It does not matter if I do this within assembly or make displayed and then edit attributes.
This is not the only situation NX freezes, it freezes with "Work on displayed assembly", moving component, constraining components, probably anything that calls for "Updating objects..."
A colleague of mine had this problem before (on NX8.0 same machine), but its was worse - it took minutes and minutes to "update objects".
So its time to figure out the solution.
And no - exporting to parasolid and back is no a solution, all the parts are reused and allready with drafting done.
I did part clean up - did not help.
It is (and was) specific to that certain assembly, wich is a part of a larger assembly. And the later is fine, no freezing, no lagging, unless of course I load the buggy one too.
Regards