Good morning all,
Started using NX11 and was informed that Radial/Hole Callout is preferred method of dimensioning a hole instead of using Feature Parameters.
This works fine on new parts that use Pattern for holes, but Legacy Parts that use Instance Array are hosed as that is not supported. Can't pick holes at all.
Same thing for use of Legacy Parts that have a tapped hole as 2 features, simple hole and thread applied, instead of threaded hole. Callout fraction for thread comes in funky.
Feature Parameters for a single hole (.500 Dia) will not allow you to change decimal places.
Are we supposed to not use clone anymore and recreate all parts new, as it seems Legacy Part support is no longer available???
This will create many extra hours on our end.
Yes GTAC has been contacted, with a response of it is now an ER.
Why is it an ER (Feature Paramaters decimal place change) when it worked fine in NX8.5.3 but is now broken??